![]() Once power has been applied to the unit, check the signal strength LEDs to find the best installation location, and then perform a phone test to register the device. In order to successfully install and set up the NX-411-US-AT-LTEUP, recommends that you create the account for the device at least 24 hours prior to physically installing it. The user will simply power everything down, remove the CDMA or GSM module, replace it with the AT&T LTE upgrade module, and then power everything back up. In a situation like that, the NX Gateway module should already be in place. The assumption is that anyone who uses this LTE upgrade communicator will be replacing an older, obsolete CDMA or GSM communicator. ![]() Because it does not include the NX Gateway module (NX592E), which is required to interface between the LTE communicator and the NetworX panel bus, it should only be used to upgrade from an older, obsolete cellular communicator to the AT&T LTE radio. As a heads up I have a house phone but it is through a cable modem.Īny information would be extremely helpful.The NX-411-US-AT-LTEUP is an AT&T LTE upgrade module for Interlogix NetworX NX4V2, NX6V2, NX8V2, and NX8E panels. My goals are as follows: to be able to activate the system for local monitoring only so I would be alerted to forced entry when sleeping, or if possible have it some how dial my cell phone if activated when I'm away. When power is restored to the system the screen will read "AD 1600" several times before the screen goes blank then returns with "d1" until finally it alternates between "01" & "05" while simultaneously displaying not ready. I have attached pictures of the keypad, board, and interior door schematics. I don't know anything about the system (codes or anything), nor do I have a manual, but am fairly handy. ![]() ****** advised it was $50 a month for 5 yrs, which is unacceptable, and they said I could not activate it for local monitoring only, which I think is bull crap. The previous home owner stated he canceled the account with ***** but that I could set up a new one. I recently purchased a new home with an alarm system installed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |